Brightfour Wire Connectors - Pack of 12 Low Voltage I Tap 1 Pin Connectors Solderless with No Wire-Stripping Required for Mid-Span Branching in Wires Connection 24-20 AWG Cable

The media could not be loaded. Awesome product! We use these to connect four strands of LED lights for a display in our store. They’re very easy to install and super easy to operate. I always hated how you needed to plug in so many different cords when you’re making continuous run. No more this is awesome! Great, value to make a display that’s priceless! The connectors are good quality and easy to install.

Great product, very solid. I like the all copper construction conductor. You can reuse these, but if you're careful only.

Makes connecting wires very simple.These worked well for connecting the various wires together for the lights on my small pontoon boat. Very easy to use. No wire stripping necessary. Just lay the wires in there and snap them closed. Should hold up for a long time.

Used these to splice a car stereo harness to an adapter harness for my car. I didn't want to cut off the existing stereo connector (or splice wire ends together) so I opted for this instead. These taps worked perfectly for the data wires, but the power and ground were a bit too thick. I ended up clipping away at the plastic on the tap and eventually got them closed well. They probably would have worked without the clipping, but they didn't snap closed and that was a concern.Powering the stereo, it seems all the connections work. I'm getting speaker sounds all around so all the taps made the connections they were meant to. They got the job done and I'm pleased with it.

I replaced a couple of JST SM Connectors in a Sole E35 Elliptical machine. The original JST SM collectors were hot glued on top of being crimped. And the wires had snapped off. I didn't need a crimping tool for these new connectors. There is a small "+" mark on one of the terminals to align the wires correctly on either side. I aligned my green wires to this "+" terminals and the red wires to the middle terminals on either side. It made it so easy to ensure that all wires were properly connecting on either side of the two connectors. Amazing, Simple & Brilliant design. Good quality.

These worked great for me! Make sure to get the wires completely down the groove and into the connector.

Works perfect for smaller gauge wires. I used in my vehicle for splicing into existing wires.

The product that I've purchased is as as bad as it is, it does not work properly and it falls apart easy. I can't get a refund because I've yeah. Almost used every one of them, and they all broke