Hogue HandAll Beavertail Rubber Grip Sleeve for SIG SAUER P365

I didn't think this grip was going to make much of a difference since I already liked the factory grips on the sig p365, but it made a huge difference! It's one of those things that you have to try to know what you're missing out on. It didn't make the my gripping the gun thick and bulky like I thought it might do. Instead it added some comfort to my hand. It feels smooth and feels like I'm gripping onto a soft gummy bear. I also like that when the gun is in a pocket holster with this grip on it that it adds additional slip protection to help keep the gun in place in my pocket. I read other reviews and comments and a lot of people were having issues getting this grip to go on the gun. I didn't experience any issues. I did not have to soak it in water like others stated they had to do to get it to go into the gun. It's not going to slide on super easily but you wouldn't want it to slide on super easily because if it did slide on super easily than that means it could slide off easily too. Also, I want to mention that this grip does not use a retaining pin like other model Hogue grips I've used. In total I had the grip on in less than 10 minutes. It requires good finger dexterity and grip to install without difficulty. This will be most likely be the least expensive and favorite accessory that I will add to my Sig P365. I would definitely purchase another one.

Makes the grip feel better in your hand. Much easier to grip. It does take some elbow grease to put on.

Fits P 365 well. Very comfortable . Good grip.

GREAT PRODUCT , FIT MY HAND MUCH BETTER AND HAS EMPROVED MY ACCURACY

It takes quite a bit of force to install this. I just ended up using muscle power and nothing else, but the instructions recommend using Windex or some other lubricant to install. I stretched it out to get it initially on the frame, then grabbed it on one end and PULLED, then alternated to the other side and PULLED again, after about 5 minutes of alternating each side, I managed to get it in the correct position. Once you get it installed it is a wonderful grip. Matches my P365 perfectly and makes the correct grip very natural and comfortable. Its made out of a VERY TOUGH rubber material with a great texture. The "Beavertail" on the back cushions the recoil of the firearm (which can be a bit jarring on the P365, since its so small). It is surprisingly affordable for such a high-quality grip, a very good value.

As stated by other reviewers, this grip sleeve is made for the Sig P365 and not the Ruger LCP Max. The SIG P365 has a relief on the trigger guard where it joins the frontstrap which allows the first finger to sit higher on the grip. The LCP Max does not have the same relief, which means the first finger sits over the molded in finger groove on the grip sleeve, and this is uncomfortable. However, after installing the grip sleeve on the gun, using a razor blade, I was able to neatly cut out the finger groove without otherwise damaging the grip sleeve. Using a hair dryer and glass cleaner, it was fairly easy to install the grip sleeve. It has made a huge improvement in my grip on the gun, and therefore my shot placement, so I recommend it until Hogue comes out with a better one. Now I have ordered one for my Sig P365.

Great Grip Sleeve for P365, feels good, much better than the bare grip alone and perfect fit

Grip arrived 30 mins ago..opened package and immediately started boiling water in coffee pot. Opened package, placed grip on coffee mug and pour the hot water. Waited 5 minutes, removed grip from mug. (be careful, water will be hot) Slid grip right in in 2 minutes. Great grip, feel.