Rockler Taper Jig/Straight Line Jig - Power Tool Accessory Jigs Makes Tapered Cuts Fast - Wood Cutting Jig is Perfect for Chair Legs - Hardware Jig Includes 36” Miter Bar – Table Saw Accessories

I got this both to cut tapers and to get straight edges on boards so I can joint them and plane them.Setting up is a snap and the parts are all quality. Lots of nice touches like grip tape strips on the top and the rulers are nice and easy to stick on.Limitations: the width of the piece to be tapered is limited but this will work for me. You need to take the miter strip off the bottom (three screws) to use this to rip boards. Not a deal breaker by any means for me, I am just trying to find a place to store it so I do not lose it.I could have built this myself but it would not be this nice and I am happy with the purchase.

Like everything else I have bought from Rockler, this assembled easily from some quality instructions. All the bits and pieces were of the quality that I would expect for a jig of this price point- there were no disappointing weak-link parts. Overall fit and finish are good and it works as intended. I would buy again.

Easy assembly and setup. Versatile. Adequate length for most projects. Well constructed. Well packaged. Clear and concise instructions. It’s simple enough and satisfying to make your own, but this product is a good value.

It's pretty straight forward to use. Once I saw how it worked I was able to make the tapered cuts on my table saw. It held It's angle when I made multiple cuts.

I bought this jig to do tapered legs for a couple of end tables believe it or not. The jig is well thought out and works great for that purpose. It's very easy to set up 100% repeatable cuts. The only downside at all is that the miter bar is very long and this jig will not work with typical factory outfeed tables unless they have a miter slot that runs the whole length of the outfeed table.

This jig is well built and was assembled in about 5 min. I was happy that the miter bar fit my unisaw perfectly.There is also a problem with the bolts that attach the clamps. Rockler seems to have intended you to use this sled for pieces less than 2 1/2in tall! I'm not sure how many legs are that skinny, but I had to replace the bolts to allow for larger work pieces. Don't forget that the sled will take some height from your saw and building tapered legs is now a two pass operation. All in all this is a good jig, with a minor issue.

I bought this because I cut tapered parts all the time. I had one of those tapered jigs that has two metal bars attached by a hinge at the top. It worked OK but was a pain to set up each time and sometimes slipped. I love the ease of setting up this jig. The clamps are a bit slow if you're mass-producing parts so I replaced them with quick-release toggle clamps but the jig is a sound investment for me.

My husband made a table and was blown away by the ease of this jig. The legs were all perfectly symmetrical even though this was his first run with it