SG06 Spark Generator Replacement for Select Gas Grill Models by Brinkmann, Charbroil, Nexgrill and Others, 6 Male Spade Connector Outlets

Fit perfect and easy to hook up. Works great

My ignitor stopped working. I replaced the battery which didn't help. I ordered this replacement ignitor and it solved the problem. I have a 6 burner KitchenAid grill. This unit had 6 sockets and I has able to unplug each lead from the old ignitor and plug this into this new unit. This ignitor is different from my original one as the original had another lead wire that allowed the turning of each burner knob to fire ignitor. This ignitor did not have that plug, but instead allows you to push in the knob that covers the battery to fire to ignitor and allow lighting of each/all burners. Its works well and I am satisfied. It look about 5 minutes to change it out.

This unit is exactly as advertised. It is an exact drop in replacement for the listed grill(s). My ignitor failed after a few years of faithful use. I looked at getting a Nexgrill replacement but the cost and delivery time were both excessive.I decided to risk a low cost unit and I could not be happier. Side by side it looks identical to the original. I transfered the wires one by one to the exact same spot on the new unit and it worked great the first time.Highly recommended

Needed to replace the ignition on a Charbroil grill. This one looked pretty close in the pictures. Upon install, it was not exact, but close enough. Just had to bend the heat shield a bit, but other than that, it was fine.

After my old spark switch broke from age, and I finally found and ordered the correct push button switch. It was a perfect fit for my Ducane grill and looked like an OEM part. It was well made and looked very durable. The only complaint would be the button where it is still rubber versus a hard plastic. The reason I say this is a raccoon somehow chewed off the old rubber button where perhaps if a hard plastic make it more resistant. Installing it was very easy and worked perfectly.

... which is to make a spark. After looking at many ignition modules and not finding one specifically listed for my CharBroil 2 burner Performance grill (yes, I like the smaller grill for certain applications), I selected the GrillKid ignition module. The single lead was the model I needed. I had to slightly bend the aluminum shroud that surrounds the ignition module, but that was no sweat. This module works well and I am back grilling again.

Fits the same as original.

It was easy to install but only worked a couple of times. Tried new batteries to no avail.