KS Hardware, Patent Pending, Adjustable Double Bubble Door Sweep, Draft Stopper, Under Door Seal for Exterior Doors, 1 3/4" x 36", White (36 inch)

Perfect fit on my 32” door. Easy install. Screw cover was a tight fit and had to carefully drive/slide it on from the end rather than snap it on. Protected it with a wood block and used a light hammer to drive it. The seals completely sealed the threshold. The outside face is already trimmed to clear the side weatherstrip. The material is a gauge of plastic heavier than most I saw in stores. It’s worth the price for the quality.

Have a beautiful front door that had a worn out door sweep. I was able to see sunlight so I know small tiny bugs had an open invitation. Got this with the measurements I needed. Fits perfectly. Sealed off the space under the door very well. Slid it in place and secured it. Great instructions. Sturdy product. Worth the money.

Used to replace seal on a 42" outside door. Fit well and easy to install, added screws to the outside to hold rubber seal against the threshold, works much better than the original.

This door sweep is a bit pricey for an extruded piece of plastic and rubber but it is nicely made. I like its adjustability, which comes in handy for tweaking it to prevent drafts. One thing to know, though, if you are interested in this item. It fits a 1-3/4 inch thick door……exactly. Anything slightly thicker will splay the edges and cause gaps to develop between the door and the sweep.

We use this on our front door that had about a half of an inch gap underneath. Although it fit tight and made the door hard to operate for a while, it sealed off the bottom perfectly.Should've put one of these in years agoIt was relatively easy to install

… but, I wish they wouldn’t have cut the outside so short. This is for our inside door leading to garage. Was not able to use the rain guard part to cover up how short they cut the other side. Had to drill new holes since it doesn’t line up with the original holes. It makes the door hard to close even pushed all the way up. The contractors who built our home put the door in super crooked since they also didn’t put the drywall in straight the door frame is not square. We added new hinges and new insulation plus this. Outside of machining issues and being cut too short on one side, it still looks better than what the contractors who built it gave us. Hoping over time the rubber compresses a bit so we can close the door normally again. It seems to help with drafts but is really a tight fit and makes the door hard to close.

This door sweep is easy to install and was able to be adjusted to fill the larger than normal gap at the bottom of the door that other door seals could not do. It has a very clean look once installed and the fit was snug enough that I did not have to use any screws. Just slide it on and adjust it up and down as needed for a good seal.

Fit was perfect and stopped the wind blowing in. Cover is a little hard to put on after the strip is screwed to the door, but tapping with a soft mallet from one end worked. Will get another one for a similar door at the garage.