Freud1/2" Bearing Flush Trim Router Bit with Tico Hi-Density Carbide for Maximum Performance - Ideal for Trimming Laminates & Pattern Routing, 1/2" Diameter, 1/2" Shank, 2 Cutters - 42-114

This router bit works great. I tried a different brand that was less expensive. But got terrible results. This Freud bit is exactly what I needed. Great cutting, ease of use, and high quality.

Not much to add. It's exactly what you expect from a Freud router bit. It's sharp, very well, durable and does exactly what it's supposed to do. Freud tends to cost a bit more than some of the more generic stuff out there, but the cost is definitely warranted.

The media could not be loaded. We bought this flush router bit to cut out wooden circles. (First you router out a groove on the bottom side, then cut along the groove with a jig saw, and then flip the piece over and use the flush router bit to clean up the edge.)Wasn't sure how well it would do on 1.5" oak slabs, but it proved itself! Great little router bit, full 1" of cutting depth, works even on hard, thick material. The cut is the just beautiful, and even with a small inexpensive trim router, it ran with no issues.Great buy!

I don’t have room for a jointer so I put an aluminum strip on top of a board and run the bit along the edge on the router table.I usually joint 3’ or shorter boards and it works well. I don’t know about longer stock but I can’t see why it wouldn’t work.

Cuts like butter. I think i might start switching all my bits to this brand

very quality product. works very well

Makes a huge mess but cuts window and door openings through 3/4” plywood or Advantech like a hot knife in butter. Leaves a perfectly cut smooth finish with no tear out, bearing rolls effortlessly around the framing but it sure leaves a massive amount of wood chips. Its also great for leaving a perfect edge at outside corners.I read one review where the person said “make sure you oil the bearing”, not sure what he got but mine has a sealed bearing, there’s nothing to oil or grease, pitting oil on it will do nothing since the bearings are sealed and have no need to be oiled.

Freud products are always high quality!