Heater Blower Motor Fan Resistor -4 Pins for Ford Fiesta Focus Mondeo Galaxy Kuga 206927 1855157 1253185 1325972

fitted in 20 minutes after watching u tube video. fan working all speeds for a few weeks now. Will have to wait and see if it lasts years but certainly cheaper a car mechanic

bought for a ford fusion and the fitting is on the drivers side of the heater matrix, it,s in a very difficult position where you need to lie on your back leaning over the doorstep and almost blindly undoing 2 torx screws after removing the wire connector, then refitting the new.if your fan only runs at full speed then it is likely that this resistor is at fault.my fusion fan was noisy when i bought it 5 yrs ago, then it went to full speed only as the struggling fan had burnt out the resistor and even after changing the resistor a few yrs ago, the fan also burnt out the replacement resistor,this time round i had to replace the fan, the heater control unit and the resistor so all is now well.the fan was also a nightmare to fit, up behind the glovebox, under dashboard and removing the fusebox, again lying on my back into the footwell.i,m a very experienced diy mechanic over 60 so wouldnt look forward to doing the job again.

Easy to fit and worked well. Saved lots ofoney doing it myself. Not hard just fiddly to get screws out.

Works fab but the fuse is awful to fit if on a ford uk and mounted on the drivers side behind the peddles.One in though it works fine and blower heater works great.

Easy cheap fix for a common problem with Fords. The only down side is that the fans don't seem quite as powerful since fitting the replacement.

Managed to fix the Ford Fiesta in a few minutes. Saved around £100 at the garage, and about half a day of faffing.PLENTY of guides on how to do it online - really simple.

Fixed air con, easy to fit

Was ok did the job