General Motors GM Genuine Parts 11610633 Starter Bolt

Real GM starter bolt. Used these on a gen 3 4.8

Two are necessary for installing a long/long bolt starter on many GM vehicles, including our 2002 vintage Z28 Camaro. While not as easy to install as the original long/short bolt starter, the long/long is a more robust unit and does fit. Do not attach the wire terminals, or the snap-on heat shield, to the starter before trying to install - There is a plastic flywheel coverplate positioned by the starter and attached by a single 10mm (head) bolt to the lower bellhousing (see left photo above) which should be removed - With the nose of the starter in the coverplate hole, position the starter/cover in place and just start the two long/long bolts - By moving the starter up by hand, the coverplate bolt can also be started into the bellhousing - Remove the two long/long bolts and slide the starter back & down for access to the electrical terminals -Connect the two wires, battery power & ignition start, to the starter studs and the snap-on the heat shield to the starter coil- Reposition starter, coat long/long bolt threads with Locktite Blue and start each into engine block - Tighten both snug then torque in alternating bolt steps. I used 12½ / 25 / 35 ft.lb. (factory spec is 37 but I chickened out)!

Muy buen tornillo, era el necesario para soportar mi marcha de la camioneta Chevrolet.

Muito bom estava a procura a bastante tempo e não encontrava então de parabens

Produto de excelente qualidade produto original GM , mas infelizmente a medida da rosca é diferente da minha S10 . Depois de algumas pesquisas descobri que a GM Brasil lançou a Blazer e S10 com medidas em polegadas e milímetro e na descrição da peça não especifica esse detalhe. Mas volto a afirmar que a peça é de excelente qualidade.