TBWHL 3D Prtiner Glass Bed Clips Swiss Metal Small Picture Photo Frame Spring Turn Clip Hanger Silver Tone Size 1 inch x 0.55 Inch / 26 mm x 14 mm 50pcs

I bought these to clip a glass bed on an Ender 3 Pro - I place two on the front edge, two on the back, and two on the left (they get stuck if you put them on the right), instead of using small binder clips. They hold tightly so nothing shifts, and have a very low profile on the bed surface to maximize the functional area. I have way more of them than I need now, but this was a much better value than some of the other options.

I was using binder clips, then I discovered these. Amazing difference, easy to clip on, and easy to remove, they even work with bed insulation, unlike binder clips. If you're looking at these to hold your glass plate secure on your heated bed, just do yourself a favor and get them, you won't regret it. They probably work great in the picture frame role too.

Works well, could be a bit tighter fit. Otherwise description is spot on!

As an artist, I hate framing my 2-D pieces because sometimes the frames take away from the piece. They also make the work heavier, making it more expensive to ship anywhere. There little clips are unobtrusive and clean looking. They don't interfere with the art piece and keeps it all simple. I frame using Plexiglass with a Melamine backing. These little clips hold everything together quite nicely.

I bought these to hold down my Ender 3 bed. They do a great job holding the Creality glass bed in-place, while being much more low-profile than the clips it comes with. This results in a bigger effective build surface. I've only used 4 out of the set, so I'll need to hunt down something to do with the others!

Like many people, I was using binder clips to secure my glass print bed to my 3D printer. They are large, which means the effective print area is much smaller, and also take up vertical space, meaning that my large fan duct would catch on the binder clips. These clips not only take up less print space, they also are lower profile, preventing the fan duct from interfering with the clips. Attaching the clips is very easy, and results in a secure bed that doesn't have any obtrusive clips hanging off the side.

They do not work they pop off

Several of my framed photos (metal frames) needed new fasteners on the back. I looked up and down the Internet for the kind I used to use--I'll call them "alligator clips". All you had to do was pinch them, slide them into place, and they fit snugly. They are nowhere to be found. The only kind were these. There must be some trick to putting them on. I couldn't slide them down underneath the glass and backing. If I tried to put them on the backing before I set the backing into the frame, they didn't hold tight. Poor design. No, I wouldn't recommend them.