STARELO 5pcs 12mm Momentary Push Button Switch Silver Shell with pre-Wiring, IP65 Waterproof Push Button Switch,Stainless Steel 1 Normally Open Without LED.

I needed some momentary on switches which DID NOT have the LED lighting that many doorbell switches use. The tiny current that passes through the LED lit switches I tried was enough for my equipment to sense that the button was being activated when it was not.These are solid. I tested all five with an ohm meter and they all work perfectly. They have nice clean "wire through hole and secure with screw" connections so you do not have to wrap wires around the screws. Plus, there is a clean barrier between the connections to reduce the possibility of shorts.They are 5/8" in diameter at the threads which is what you need to fit in the standard wall plates made for switches and cable pass through. Be careful because some switches I looked at were larger and would not have fit in those plates.I also like that the button extends out from the switch, rather than being flush or slightly domed. I had tried those other types, but you had to push the button into the switch, making harder with large fingers.Highly recommend.

buttons work great for 18V batteries. They withstand the heat unlike some others i have tried using. good quality

Not the first time we are ordering, and still not disappointed by this product. Love the design and often use these in our electronic projects. Work as advertised, easy to install and use, and flush against even surfaces. Also include a rubber seal in case you need it, which we think is a great addition. Made of great quality materials, and function very well.

I have ordered these a couple of times and used them for various projects. Some even outdoors for manual activation of my gate controllers. They have an o-ring to keep them water proof, and are pre-wired to avoid overheating the switch body. They look good and work reliably.

These work as advertised and install easily, but the wire-to-button is a bit weak and could benefit from reinforcement with extra solder.

Really nice switches being water resistant and all. Wish I could get the hang of this metric stuff, these switches are kinda small. I want to put a momentary switch on my snowblower as a shut down switch to replace the plastic "key" that they use. I will use them for something but I am looking for something a bit larger in dia.

Small and reliable.

Great size little mini momentary button. Great value. Looks clean when installed properly. The switch quality seems great however I get some static and fuzz on my base when I press down. I've installed a resistor which helped a little bit. I think I'm going to install another couple resistors to see if I can get the fuzz to go away. This is on a passive bass and I feel that this issue probably would cease to exist on an active bass. I've only installed one of these and they're still a handful of them left in the pack. If the static goes away upon switching it out for a new one I will update this.