Broan-NuTone BHFLED110 PowerHeat Bathroom Exhaust Fan, Heater, and LED Light Combination, 110 CFM

I would agree with some of the other reviews, replacing an existing fan with this one can be a bit more challenging as this one is designed to have full access from the rafters below with the ceiling opened. With some planning the installation challenges can be mitigated if you are doing a replacement like I did, but it still had its points during installation that wasn't fun, unfortunately the wiring was also on the opposite side from the old one and the new one is on the side in a cramped spot in the attic with poor accessibility so it required some prewiring of some lengths of Romex before setting it in place, so keep that in mind too if it is going to be in an area in the attic that will make the wiring hard to access.The exhaust fan works great, and is much quieter and more powerful than the one it replaced, I think the old fan was undersized as there was always still lots of moisture on the walls and ceiling and it was starting to cause mold issues (why proper CFM is important), but this one keeps the moisture in the bathroom during even a hot shower to almost nothing now. The LED light is very bright, we run the fan off a timer while we shower and many times we don't need to turn on the main lighting in the bathroom when this is on. The heater works pretty good, it seems like it is a little louder than I would have expected and noticed a slight vibration sound when it is on, but it has heat coming out almost instantly. I did an amp check with the heater on and it draws just a bit over 12A, it calls for a 20A circuit and 12 AWG wire for the heater and that's exactly what I used and pay close attention if you are going to use a timer for the heater and make sure it is rated for it.

Good product. Works as described. For retrofit, ensure the size fits your existing opening as the installer had to cut into the ceiling. Powerful and quiet exhaust and good heater. recommend product!

Nice heater that warms med size bathroom quickly. The noise level is low and the installation wasn't complicated. It funtions well.

Very difficult installation. Flanges cannot overlap the sheetrock and bend just by holding the unit with your hands. It required stiff insulation on all sides to hold it in place horizontally and I had to shim the built in supports to get the right height.

Very strong fan. Exhaust steam out of bathroom. Fast heat is very quick. Well made heavy duty. Easy to install.

The heater is so amazing on the cold mornings are the shower. Even just turning it on while getting ready hears up the bathroom nice and toasty. The fan is also much stronger than my previous fan that could barely hold 1 sheet of toilet paper from the airflow suction.

Reading the negative reviews on this product leaves me puzzled. Yes it was a bit of a challenge to install but not all that bad and not any worse than the last one I put in. No, it doesn't come with switches but if you can't but switches and install them yourself you SHOULD call an electrician. Noise level is just fine, if you are moving air there will be some noise. I love the look, it throws heat instantly, draws a good level of air through the vent and the light is super.

I had my electrician wire it up. The led did not work. The fan and heating functions both work. Product is broken. Amazon rep said i had to return the entire thing. That would require hours of taking the housing (the working part) out of the ceiling, going to a return location, and sending the entire thing back. I only need the plate with the LED that snaps onto the housing in the ceiling. I tried explaining that this to the customer service rep to no avail. I was out on hold for 25 minutes. I have always used broan-nutone for vent fans without any issues. Unfortunately they sent me a non-functioning product.