DASBET 3 Jaw Pilot Bearing Puller, Heavy Duty Pullers Set Bushing Gear Extractor Wheel Bearing Puller Automotive Machine Tool Kit for Car SUV

Lighter weight that so.e I've used but for small bearings It would.do fine

Bought this to pull out my motorcycle wheel bearings with a 3/4 inch center hole. Truly a piece of junk and definitely not worth the money. It has three legs on it to grab the bearing, but when I tighten it up one leg would always sit cockeyed.I should’ve spent my money on a slide hammer. I ended up taking the wheel into a motorcycle shop and that’s what they used on it.

I had to change an inner spindle bearing on my 89 f-250, and I bought this tool specifically to pull it out. I was eventually able to make it work, just barely. I had to sharpen the “teeth” that grab the underside of the bearing, because the way they were cast didn’t allow them to grab well. In the end, the tool did the job and didn’t cost much, so I can’t complain. It even survived without damage, which is a bonus. I would give it 5 stars if the pulling threads were finer, the teeth were machined instead of rough cast, and if there were any instructions included.

The horizontal bar bends VERY easily. I had to disassemble and flip the bar over to bend it back. I was able to remove the bearing after repeating this several times. Used on removing front load washing machine bearings.

Tool is exactly what you would expect for the price. Tool will not work on a 2003 Honda Shadow Sabre 1100 without some modifying the jaws. Did work after modifying.