1/4" Irrigation Dripline Tubing (100 Ft Roll) - 6" Emitter Spacing - 1/4" Drip Irrigation Fittings Included

My local box stores tend to either sell out or not carry these. I was disappointed with the 12 inch spacing for my raised beds and container gardening. This works fine. I don't recall getting extra little connectors with it. But I've learned on the connectors to get the ones that look barbed on the end. The even connectors are nearly impossible to use, even though I boil a pot a water and put it in a thermos to heat the ends of the small tubing. The barbed T's and dual connectors are a breeze to install once you warm the tubes.

Shipped and delivered promptly. It works well. It is difficult to insert 1/4 inch connectors but this is likely by design to lessen the chance of leaking. I plan to try the hot water trick next instalkation.

Works great. Very sturdy. Great value.

OK.

Great addition to my watering system.

I use irrigation emitter tubing to water 5 large raised garden boxes with a timer control. My existing tubing is old and over the years I've even tied knots in the ends of the runs when the end blew out. I was happy to see that with this product I could now go from my old 12" spacing to a 6" spacing and am delighted with the results. Installation was as expected since the package included 10 end stoppers and 5 barbed couplings to connect to the mainline tubing. This would not have be enough to do my job had I not been able to reuse some of my old fittings. You do need some strength to push the ends into place. (I did not notice the fine print until today that said to "apply heat or hot water to tubing end to soften it, to more easily insert fittings.") Will certainly purchase this product again if and when we add more to our garden.

Quality is good It’s flexible. Works very well. Just what I needed for watering my vegetables. I recommend this product.

Love the 6 inch emitter spacing. The drip line works as it should, it seems durable and was definitely long enough! I would highly recommend laying out the tubing in the sun for a few hours to soften it up. You might need pliers to attach this drip line to your setup, the line was a little too stiff to go on to the barbed connections easily. But that also means its not going to come off very easily, which is definitely a good thing.