mxuteuk 6 Pairs 22AWG 2 Pin Electrical Connector IP65 7.87in/20cm Male Female Wire Connector Extension Cable 15mm for LED Strip Lights,Car,Truck,Boat,Indoor/Outdoor

I wanted to have an alternative way to charge these solar lights I bought. Was a great kit of 4 lights and 4 solar panels. These need slight modifications but the DIameter is EXACTLY correct, along with pin size and pitch (???)/Spacing (???). I plan to pair this with USB A and USB C DC connectors so I can charge these lights off of a battery pack when I forget to use solar, or if it's a cloudy day. I use these "Security" lights for camping as perimeter lights. Mostly because, like a lot of things off of Amazon, I bought literally like 30 of them in white and 20 in black. LOL... SIGH... What's also nice about this set of connectors, I can use the female ends and marry them to male USB ends to charge the lights, and then use the Male Ends with the solar panels and marry them to female USB ends to charge things via solar. All without needing to chop the cords on either parts of the light. These more than work for my needs.

Work as expected. I used them to piece together my own turn signal kit for my side by side. The i only issue I has was that the threads did not fit the connection of the kit. Overall good product.

Work good

I'm very happy with these connectors and I've purchased quite a few of them in the past. They're extremely secure and have proven to be weather resistant. Not submersible, but certainly fine for damp applications. I would highly recommend these connectors, you'll be happy to have them in your shop.

Not compatible with Philips hue, which is why I bought it.

Had solar that needed connectors replaced, works like a charm

First, these are good connectors that match the description. I probably will buy them again. My gripe, if any, is that it is extremely important to line up the male/female ends before trying to mate them. This seems obvious, I know, and it's not too difficult when both ends are very well-lighted and out in the open. But if you connect one end in some kind of enclosure that is not well-lighted--or place it anywhere that does not provide extremely clear visual access to both ends when you mate them, it will frustrate you. I'd pay an extra buck or so if the outsides of the connectors had, say white lines to enable easier alignment of the ends when trying to mate them.

Works as it should perfect for pre-plugged two wire strobe systems or LED strips that require a two plug lockable connection. You can make your power cord as long as needed by using the male and female plug adapters on the end. Be sure to pay attention to what you're doing or check polarity.

Nada que ver con lo que describe en su publicación es un asco