SpeToolCarbide Compression Flush Trim Router Bit 1/4 Shank with Top & Bottom Bearing, 1/2 Inch Cutting Dia Pattern Template Flush Cut Router Bit for Woodworking Trimming

Works great goes through wood with ease much quieter that strat bits

Amazing bang for the buck. Have given this bit much use and still running strong. Commercial

Se ve de muy buen material, lo probaré y seguro compraré de nuevo

Not too bad but not the greatest bit I’ve used.

If you purchased this bit I would stop using it immediately. I spent last night in the ER due to this bit bending on me after using it the first time. I will not include photos of my injury but I was lucky enough to keep my finger.I did include the piece I was working on. I was removing a small bit of wood left over in the last hole. It was not more than 1/8” by 1/8” that the drill bit left over. Nothing that should have come even close to taxing the bit. This is where it grabbed the piece and threw it tearing out the bottom of the walnut.In the pictures you can see the slight bend in the stem. It was almost fully inserted into the collet and it still bent. When I got back home today I turned the router on to try and figure out how this happened and I found the bit wobbling around. My first thought was I didn’t tighten it down enough so after checking that and making sure it was completely tightened I pulled the bit out and rolled it on my table. It’s very easy to see the wobble in it then.I am incredibly fortunate to still have my finger. I would not recommend this bit to anyone. Please be safe out there everyone!

The angular cut up and down seems to cut cleaner. I use on a minimum 2hp router which seems to work best. Good Quality and clean cut.

Awesome bit.

I needed this bit to smooth out the edges of some trays I was making. It cut nicely, didn’t chip, didn’t cause jumping. Didn’t even really need to sand much afterwards.