Pair of 7' Garage Door Cable for Torsion Springs

loops were tight and cables are stiff so it took some doing to get them on the door. But they are heavy duty are working fine. Not sure about the durability yet. ask me again in ten years.

Easy to install and worked great !

Cables fit like the originals. No issues with installation or operation. As long as you know how to deal with the spring, there should be no problem installing these replacement cables.

It's a door cable.

Good quality cable, one issue is that I could not replace it, beyond scope of what I felt comfortable doing.

It’s a good product. No downside

Perfect git. Easy installation. Couldn't be more happier. Very satisfied with this product. Hope it holds up for another 30 years like the old one did.

Just what i needed good product

Recieved these this afternoon. Took about an hour to install but half that time was cleaning the rust off the pin on one side where my original cable broke due to rust. Installed fine. Tested the door thoroughly and didn't even need any adjustments after install. They're a little thicker than my originals but still fit the roller fine. Saved me $200+ I'm sure. Can't speak to durability or longevity yet but they seemed well built to me.

I'm a do it yourself-er, and usually not afraid to try to fix anything. This one scared me a little as we have an extremely heavy garage door so the springs are under a huge amount of tension, especially when closed. Also, some Youtube vides suggested there was some tweaking of the spring position, etc. I decided to give it a try, and found that it works well without any tweaking.Could not find these cables anywhere else, so grateful to find here. While I was waiting for these cables to arrive, I removed power from the garage door opener (pulled the plug) removed the defective cable, and then released tension on the non defective one so it could also be removed, and the garage could be closed. There are ways to do this by using vice grips. Youtube it. Be careful. Do this with the garage door completely open. Essentially you can turn the "shaft" that the pulleys are on to release tension. Make sure you vice grips the rails by the rollers so the garage door doesn't come crashing down when you remove the cable. Some doors are unbelievably heavy like ours.Once you get the cables, wrap them back on with the garage door completely open. The hardest part for me was knowing how many wraps. I wrapped them until there was a bit of tension on the pulleys. Success. The garage door has been going up and down successfully for about 3 weeks now.

One of my garage door cables broke, which made the garage door lopsided. Couldn't find any cables in my local town. I knew I would easily find them on Amazon. Bought from N Global. Replaced the broken cable with the new one. The new cable had more tension than the old cable on the other side, which was a little loose compared to the new cable. The door was better, but still slightly lopsided. I replaced the other cable as well. Now the door is working perfectly and is straight and level. I thought I would have one spare cable as I only needed to replace one. As I found out, it is better to replace both cables with the new ones. The cables were very easy to replace.

The new cables were slightly longer than the original cables, so had to replace both cables, plus make adjustments so that the cables were not lose

The cables arrived within a few days of ordering as stated and are good quality. Install was very straight forward. I would recommend this product if you need a cable replacement for a 7 ft residential garage door that requires torsion cables