Nilight 3/4Inch Round Marker Light 10PCS Amber LED Turn Signals 3 Connectors Side Indicator Bullet Clearance Lights IP68 Waterproof for Trailer Truck Camper Van Boat Bus

Very bright. Good quality so far.

These are the answer to the 3-bar on back of a trailer. Just drill three holes and put these in to replace that 3-bar light that’s required on trailers. Then it’s very hard to get these damaged. But if you do damage a light, then simply pull the one out and replace. Not the whole 3-bar. But these are so small and out of the way I haven’t had any problems. And they are unbelievably bright. I even hooked up the brake light side of these to the trailer brake wire and they work great as clearance lights and brake lights.

Product is very bright and is very easy to wire up I drilled holes into my valance and thy slide right in just make sure you don’t cut your holes too big but product is a good one the only trouble was the wires are small and hard to mess with a little bit.

These LED lights are bright and look nice when installed. I have purchased multiple sets over the last couple years.

Very bright! Easy to install due to the rubber grommet around the light. When stripping the insulation off the wires I discovered there’s only about a half a dozen tiny little strands of actual wire. But evidently it’s enough.

I got these to use as running lights on my mini bike, they are perfect. Drilled holes where I wanted them and wired them in, they work perfectly. Very bright and low power consumption.

A simple but great product. Simple installation. Works like a charm.

Neat little lights serve their purchase I bought them for an aftermarket bumper to use as tag lights and they fit the hole good . Haven’t had any issues with water getting inside them so I will say they are best value for your money with the price