McNettSeam Grip Sealing Repair Kit 30 ml

Very good stuff. Very sticky. Get it under the seam tape and stick seam tape back to tent. Seems to work well. The tools they give you to apply it are a bit rubbish so you may have to use small painters brushes, cotton buds and cocktail sticks. As others have mentioned, don't forget to talc afterwards!

Yeh ok

It's amazing glue just takes a couple of days to fully set.

I used this to seam seal a tent. Very difficult to apply and doesn't result in a well presented job. Did some reading up and tried diluting with white spirit to improve flow into stitching, also to make application easier.It seems like a good, well adhering, flexible sealant... My struggle was in the application. Perhaps patience and a different technique is required.

After the drawstring on a couple of my Goretex jackets came unstuck after washing, I enquired about professional repairs, and the estimated £30 per jacket seemed fine, but the 3 month wait wasn't, so I decided to try self repair.McNett appear to be the leaders in the field of garment repair, so I choose this product. The application of the product is relatively simple (wear disposable gloves), with the main issue being keeping the jacket flat and stable during application and drying. In the end I used washing clothes pegs to hold the seam together.I gave the glue 24hrs to cure before trying the seams. So far I have the seams have held, but only time and further washes will confirm that.

This is easy to apply with the small or large brush that comes with it, I used the small brush for a 1 inch tear on one of the pockets on my leather golf bag. Following instructions I placed a thick layer onto the tear and spread about 5 mm each side. It had set when I checked around 24 hrs later. I tried pressing the pocket to see if there was a good bond and it does not look like the tear will widen. Can bearly see the tear and I'm confident it is now fixed. I read it withstands for pulling forces like if you had a tent tear or something so also multipurpose. For the price its good value and ice still got most of the tube left shoud I need it for another day. Would recommend.

I have an expensive marmot coatz it's 10 years old now and some of the stitching that held on the velcro has broke , I used this to adhere the velcro fasteners back onto the coat because otherwise it meant undoing two lots of double taped seems to get at the stitching underneath, this stuff did the job, I applied and then held in place with pegs overnight whilst the coat hangz it formed a very strong bond and I am very happy with the result, immersed in water and has now been through the wash and it holds. Great product which means I don't have to spend 300 pounds.

So I had a complete failure of an entire sole falling off a neoprene boot, after someone on social media recommending this product, I set about cleaning and prepping, then used the entire tube to coat the sole and offer it up to the boot.The consistency was ok, I’d have preferred the viscosity to be a bit more dense but it worked, if you could get an item flat it would run.It came with a screw on leaky brush head, this was brilliant for squeezing and aiding application onto entire surface. Made the job much more precise.The boot was gaffer taped and cable tied for 24 hours and I now have a serviceable boot for work once again, I have used the boots for about a fortnight and so far no evidence of separation and it seems malleable enough to cope with the bending of the sole etc.