2025 Upgraded 3392519 Dryer Thermal Fuse WP3392519 Replacement for Whirlp00l Maytag Dryer Thermal Fuse Replaces AP6008325 3388651 694511 WP3392519VP 80005 ET401 by Romalon (3 Pack)

Fits perfect. Got my dryer running again. Great price. Good product. Yet to see if there is any longevity but I have my fingers crossed. Even if it lasts 5 or so years, it'll easily be worth the purchase. I got three of them in a pack so it should work out just fine. 😁

These Thermal Cut-off Fuses worked perfectly for my Kenmore 700 series Dryer. Make sure to verify your exact Dryer Model because my Fuse was behind the (not behind the back Dryer panel) Lower Front Panel which is the only panel that needs removed. Also unlike a YT Video that shows the Front Blower & Drying Tub/Belt needs removing 1st, the job is "Much Easier" if done in the following (approx. time approx. 1.5 hrs.) manner.1.) Make sure the Dryer Power Cord is unplugged.2.) "Pull" the Dryer away from the Wall & Remove the Dryer Vent Hose from the Dryer Exhaust Vent . MAKE sure to clean the (if needed) Dryer Exhaust Vent & Vent Hose of any seen Lint.3.) Now remove the Lower Dryer Front Panel & Gently lay the Dryer on it's "LEFT" side. You will then have easy access to the Thermal-cut Fuse that can be seen from Rt-side (with said Panel removed) opening.4.) Using the proper Tools , remove the "2" Wire Connectors that are attached to the "2" Thermal Fuse Tabs paying close attention (I marked the Front wire with a Permanent Marker) to their orientation for proper reattchment later.5.) Using a 1/4" Ratchet w/short "Magnetic" extension or similer & a small Socket that fits the "Single" Attachment Screw ...remove said Screw & then pull out/remove the "Blown" Thermal Fuse.6.) Now, install the new Thermal Fuse with a short Magnetic Extension Socket ...being careful "Not" to drop the single Thermal Fuse "Attachment Screw" down into the Dryer Cabinet.7. Now, before reattaching the Dryer Vent Hose ...push your Dryer back closer to it's Electrical Wall Outlet & plug it in to check "IF" the Dryer runs now. If it does then unplug the Dryer again & pull it out from the Wall again to reattach the Dryer Exhaust Hose.8.) Finally ...Pop your lower Front Panel back on & reposition your Dryer to it's normal running location & plug the Power Cord back into the Electrical Outlet.

Worked great!

Great replacement part. Hopefully I don't need the other 2, but have them off needed

I had recently realized that my dryer drum rollers had went bad and replaced them. After the repair, the dryer wouldn’t turn on, at all, and it turns out that when dryer would turn on but not spin, it caused the thermal fuse to overheat and blow out. I found this replacement piece and it came quickly. The repair was quick and easy; it was as simple as removing the bolts on the back of the dryer, unplugging the old fuse, and plugging this one up. From what I can tell, the piece is high quality and felt/ looked the same as the old fuse that had blown. Dryer turned right on and is working beautifully!

This part works as advertised. It is a bit difficult to install. This is the third or fourth one i have replaced. They were from different Amazon sellers. Cheap part that does not last. Glad I don't have to pay over $100 for a service call to replace a $2 part.

Very easy to replace ! fixed my dryer problems without calling a repair service ! saving a lot of money !

Fit like a glove