Flybold Small Flag Case for American Veteran Burial Flag - Mahogany Frame | Military Shadow Box for Army, Navy, Air Force, Marine | 3x5 ft Folded Flag Display Case Set with Certificate Holder

This case is beautiful. The finish on the wood is just so pretty, I really enjoy looking at it. We did have an issue with the first one sent having broken glass despite no damage to the box, but a replacement was sent. I'll definitely buy again if I aquire another certified flag.

Very nice and at an excellent price

When it arrives a few months back it looked great. I have been waiting for a few medals to put in. This is for my grandfathers flag from WWI. yesterday I went to put it together and found bubbles in the cheap tape that is used for the "mahogany" colored veneer. Its not even a plastic venire, but cheaply made tape that doesn't stick well It is said, I paid good money and it will probably not be used in the crappy condition after sitting in my office for a few months.I would not advise purchasing this.

The screws pulled out on the back and they where not near long enough to do anything and the tabs bent with no pressure, the screws barley went threw the tabs.Very cheaply made

Glass was cloudy and weAs not glass at all it was a plexiglas

This product was delivered clean well packaged, and ready to install without additional work. Planning to use this one again compared to other competitors for the above stated reason.

Great way to display my dad's military flag. Plus the best price I could find.

The front and outer sides look great. I had trouble actually fitting the flag I received at my Dad's burial into the case. I don't know the flag's dimensions, and I didn't want to unfold it to measure. The guide for getting the right size is a good one, though. My flag is 21" across the base and approximately 13" from the top corner to the center of the base. However, when it came time to fit the flag into the case, I had to stuff and tuck a lot. Some of the drill holes for the holders on the back were too close to the edge of the compressed wood, and tore out. I had to redrill the holes further in. One of the pictures I submitted shows the big gap as the little metal holder struggles to hold the back into place. I better not move the case around much, it might pop. My flag is a very heavy material and the stars are stitched into it. And the side where the flag edge with the grommets folded in was very thick. I think the case could be just a little more roomy from front to back, maybe a forth to a half inch, and it would have been perfect for me. I like the looks of it from the front, so I am not totally unsatisfied.

The box is nice quality, well made..however, you better have your flag folded right cause there isnt room for sloppy error.. the back is held on by very small screw hardware that will pop under pressure..1/2" nail tacks might be better..