N Connectors Male Connector for LMR400 Cable Belden 9913 RG8 Cable Nickel Machined Brass Construction (4piece clamp)

if they had video attached with these fittings would be great. once you get them together there solid

These are a joy to install. Can install a connector from start to finish in under 5 minutes. I used these for my 2m halo project, and installed them on 50 and 75 ohm coax. Used the 75 ohm coax to make phasing lines for feeding 2 loops to one 50 ohm feedline. If you're going to use them on RG-11, you'll need to ferrule the center conductor so that it's big enough to solder on the brass center pin. Will definitely be buying these again! 73 de KC3LMP.

Professional quality connector . I used it for LMR 400 between the radio and the antenna.

Once you do your first one the rest are easy check out the videos and the photos of this type of fittings.

Seem to work well once I figured out how to install them. Some simple installation instructions would have been helpful.

Good quality connectors for LM 400 cable and easy to install yourself. Comment for a ham operator for 50 years.

as expected

good product

Center pin perfect fit for Beldon 9913 (this connector won't fit RG8U). Ground braid treatment (clamping nut and braid clamp) is neat. Assambled contact condition is stable. Stress on the braid layer is minimized once clamping nut secured. Only concern is the clamping nut (inner diameter) slightly large not tight fit to 9913 so water ingress protestion is not high. But this is likely not considered an outdoor connector to begin with.

The machining and finish of these connectors is excellent. Was a perfect fit for my Belden 9913 cable. No instructions included, but, it was easy enough to figure out how to prepare the cable end and fit the connector. Very nice quality, I have already ordered more of these. Highly recommended.